BT OM, OMW, OMC, OMCW Pallet Truck Manual

Pallet Truck Model: OM, OMW, OMC, OMCW
Publication 153875-040
English 2005
Format: PDF

BT OM, OMW, OMC, OMCW Pallet Truck Service Manual: 369 Pages

Note: This is applicable for the OME100M, OME100, OME100MW, OME100W as well.

Pallet Truck Manual Table of Content:

• Introduction
• Technical data
• Maintenance
• Oil and Grease
• Drive unit
• Tranmission
• Brake
• Electrical System
• Hydraulic
• Valve
• Lift Cylinder

Getting the truck in order
• Cut away the band (a, pic. 1) holding the forks onto the pallet.
Take out the forks.
• Remove the battery hatches.
• Remove the carton of accessories and the can of oil.
• Cut away the two bands holding the truck to the pallet (b, pic. 1) at the mast. Leave in place the two bands by the battery compartment.
• Remove the boards between the cabin and the mast, one from each side of the cabin (c, pic. 1).
• Remove the supports from under the mast’s cross and top joists and at the mast’s shaft pins (d, pic. 1).
• Remove the pallets stacked under the mast.
• Affix a hawser to the upper section of the frame. See pic. 2.
• Affix two hawsers behind the support arm wheels.
• Cut away the two bands holding the truck to the pallets at the battery compartment (e, pic. 1).
• Lift the truck using a truck and an overhead crane.
• Remove the double bands and boards from the cabin.
(f, pic. 1).
• Fill the hydraulic system with the accompanying hydraulic fluid.
• Fit the rollers for the battery compartment conveyor.
• Connect the battery

Lift the fork yoke at the top and fit the forks.
• Execute preventative maintenance as per instructions for the 250-hour service interval. See section P2.
• Try, if possible, to re-use the pallets and other packing as much as possible.