Case CX350C, CX370C, CX380C Excavator Service Manual

Table of Contents

1. Content
2. Introduction
3. Engine
4. Hydraulics System
5. Frames and Ballasting
6. Tracks and Track Suspension
7. Cab Climate Control
8. Electrical System
9. Booms, dippers and buckets
10. Dozer Blade and Arm
11. Platform, cab, bodywork and decals
12. Special Tools Index
13. Hydraulic Schematics
14. Electrical Schematics

Manual Extract: Bucket – Install

1. Clean each pin and pin hole.

2. Place the back of the bucket parallel to the ground.
Use a hammer (4) to push in the bucket side pin (3) and arm side pin (2), and then install the bucket (1).
• If the pin is hard to insert, there is a load on the pin.
Do not force it in. Adjust the bucket installation position.
• When inserting the pin, be careful not to damage the installed O-rings or dust seals.

3. Install the bolts (1) and nuts (2) to the bucket and arm side pins.
• When installing the pin bolts, leave about 1 – 2 mm (0.039 – 0.079 in) of gap between both nuts and the retaining ring.
• Grease up.

Identify the Tier Level of your Equipment (Read our Article on Tier Level )