Case Farmall 45A, 50A Tractor Service Manual

Table of Contents

1. Introduction
2. Engine
3. Clutch
4. Transmission
5. Four Wheel Drive
6. Front Axle
7. Rear Axle
8. Power Take Off
9. Brake and Controls
10. Hydraulic Systems
11. Hitches, Drawbars and implement couplings
12. Steering
13. Electrical System
14. Platform, cab, bodywork and decals
15. Special Tools

Manual Extract: Engine – Install – To frame

Prior operation:
Engine – Remove Separating the tractor at the engine/frame (10.001) 1. Attach a chain sling to the two hoist eyes on the engine.
2. Attach a suitable hoist to the chain sling and raise the hoist enough to support the engine.
3. Remove the engine from the engine stand.
4. Using the hoist, position the engine in the frame, aligning the mounting holes in the frame with the mounting holes in the engine.
5. Install the engine mounting bolts (1), on both sides of the frame. Tighten the mounting bolts to 139 – 175 N·m (102 – 129 lb ft).
6. With the engine securely installed into the frame, remove the chain sling from the two engine hoist eyes.

7. Reinstall the radiator, (1), into the tractor.
8. Reinstall the lower, (2), and upper, (3), radiator hoses.
9. Fill the radiator, (1), with new coolant to the proper level.
10. Reinstall the muffler and exhaust pipe, (4), onto the exhaust manifold.
11. Reinstall the air cleaner assembly, (5), onto the engine.

12. Reinstall the power steering reservoir and mounting bracket, (1), onto the engine. Reconnect the hydraulic lines to the reservoir.
13. Refill the reservoir to the proper level with CASE IH AKCELA HY-TRAN® ULTRA™ HYDRAULIC
TRANSMISSION OIL.