Case Puma 185, 200, 220, 240 CVT Tractor Service Manual

Table of Contents

1. Introduction
2. Engine
3. Clutch
4. Transmission
5. Four Wheel Drive
6. Front Axle
7. Rear Axle
8. Power Take Off
9. Brake and Controls
10. Hydraulic Systems
11. Pneumatic System
12. Hitches, Drawbars and implement couplings
13. Frames and ballasting
14. Steering
15. Wheels
16. Cab climate control
17. Electrical System
18. Platform, cab, bodywork and decals
19. Special Tools

Manual Extract: Brakes and controls – Hydraulic service brakes

Front service brakes
The front service brakes are hydraulically operated wet disc type. The discs are located in the final drive cases of the front axle and are splined to the differential output axle shafts.

Rear service brakes
The rear service brakes are hydraulically operated wet disc type. The discs are located between the rear axle housing and final drive housings and are splined to the differential output axle shafts.

Parking brakes
The parking brake is controlled mechanically. It acts on the rear pinion gear shaft and is controlled through a hand lever located at the left of the driver’s seat.
When the parking brake control lever is raised, the tensioning cable acts on the actuator forcing the pads against the six brake discs splined to the tractor rear pinion gear.