Case SV212D, SV216D Vibratory Roller Service Manual

Table of Contents

• Content
• Introduction
• Maintenance
• Engine
• Hydrostatic Drive
• Hydraulic System
• Frames and Ballasting
• Steering
• Cab Climate Control
• Electrical System
• Platform, Cab, Bodywork and Decals
• Special Index Tools
• Electrical Schematics
• Hydraulic Schematics

Manual Extract: Compaction front drum – Install

NOTE: For more details refer to Compaction front drum – Component identification (44.160).
1. Place the frame on suitable supports on both sides.
Hang the drum and lift it by using adequate lifting equipment, and mount it into the frame so that the drum does not bump into the frame.
2. Make sure that there is a gap of 22.0 – 26.0 mm (0.9 – 1.0 in) between the frame and the drum on both sides.
3. Screw the bracket on the right side to the frame. If it is necessary, use shims.
4. Slacken the bolts on the left side of the drum.
5. Mount the weight to the frame and then retighten it by means of bolts.
6. Using a square, measure the distance between the drum and frame near the joint at various places (refer to figure 6). The drum must be axially centered.
7. Lift up the drum and remove the supports.