Fendt 309, 310, 311, 312, 313 Vario SCR (3b) Tractors Workshop Repair Manual

Applicable Models:

• Fendt 309, 310, 311, 312, 313 Vario SCR (Tier 3b) Tractors Workshop Repair Manual – 1573 Pages
• Fendt 300 Vario SCR (Tier 3b) Wiring Diagram and Schematics – 95 Pages
• DEUTZ TCD 4.1 L4 Engine Manual – 331 Pages
• VarioGuide NovAtel & Trimble – 116 Pages
• Carraro Mod. 20.19 Steering Axle Manual – 93 Pages
• Operators Manual – 179 Pages
• Maintenance Manual – 128 Pages
• Fault Code Table – 282 Pages

Workshop Manual TABLE OF CONTENTS

• 0000 Tractor / General system
  Overall system/tractor
  B Faults
  D Component position
  F Settings and calibration
• 1000 Gearbox
  1005 Transmission control unit
  1010 Differential
  1015 Final Axle drive
  1030 Hand brake
  1050 Housing
  1070 Brake system
  1080 Vario unit
  1220 Live PTO
  1200 Front PTO
  1320 Front wheel drive
  1430 Hydrodamp
  1490 Pump drive
• 2000 Engine
  2000 Engine — general
  2010 Cylinder head
  2050 Cooling system
  2060 Fuel system
  2210 Crankcase
  2312 Lubrication
  2400 Exhaust gas system
• 3000 Front axle
  3050 Suspension
  3120 Steering cylinder
  3180 Cardan shaft
• 5500 Air conditioning system
  5500 Air conditioning system
  
• 8000 Accessories
  8000 Accessories
• 8100 Cab
  8100 Cab
  8113 Cab/heater
• 8600 Power lift
  8610 Electrohydraulic EPC control
  8631 Power lift control
• 8700 Three-point hitch
  8730 Lift arms
  8740 Support
• 8800 Compressed air system
  8800 Compressed air system
  8820 Brake fittings
• 9000 Electrical System
  9000 Measure and test
• 9400 Hydraulic pump installation
  9400 Hydraulic pump installation
• 9500 Hydraulic equipment
  9600 Hydraulic equipment
  9605 Hydraulic connections
  9620 Valve installation

Manual Extract

This workshop manual provides notes for trained technicians to maintain our tractors. Read and observe the information in this documentation. This will help you prevent accidents.

Intended use includes maintaining operating the service and maintenance conditions as specified by the manufacturer. Operation, maintenance and repair of the tractor may only be carried out by people who are familiar with this equipment and aware of the associated dangers. Ensure that this documentation is available to and understood by everyone involved in operation, maintenance and repair. Not observing this documentation
can lead to faults, damage and personal injury.

The prerequisite for the Fendt 309, 310, 311, 312, 313 Vario SCR (Tier 3b) tractor being correctly serviced and maintained is the perfect condition and availability of all necessary equipment, standard tools and general workshop equipment as well as special tools. Special tools must only be used where absolutely necessary. The tools are displayed where they need to be used in each case.

The machine must be maintained according to its proper use. Always replace parts with genuine FENDT spare parts! When ordering parts, please provide the chassis number as per the most up-to-date spare parts documentation.

Workshops should also refer to documentation on maintenance work and technical data. Once maintenance is complete, take a test drive to ensure the vehicle’s correct operation and road safety.