Hino 145, 165, 185, 238, 258LP, 268, 308, 338 Series Year 2009 Repair Manual

This is the Repair and Service Manual for Hino Truck 2009

Series: 145 (NA6J), 165 (NB6J), 185 (NC6J), 238 (ND8J), 258 (ND8J, NJ8J)), 268 (NE8J, NJ8J), 308 (NF8J) and 338 (NV8J) with J05D-TF, J08E-TV and J08E-TW engine

Format: PDF
Language: English

• Hino 2009 Truck Manual for 145, 165, 185, 238, 258LP, 268 and 338 Series – 1263 Pages
• Hino 2009 Owners Manual – 316 Pages
• Hino J05D-TF Engine Manual – 396 Pages
• Hino J08E-TV and J08E-TW Engine Manual – 424 Pages

This workshop manual has been prepared to provide information covering repairs on 145, 165, 185, 238, 258LP, 268 and 338 series Hino 2009 trucks.

To use Hino 2009 trucks for years, smoothly, safely, and economically without trouble, it is important to perform inspections.
Maintenance required to be performed is the responsibility of the owner. Some recommended repairs of your truck are mentioned. When making any repair of your truck, be careful not to be injured through improper procedures.

As for maintenance items, refer to the Owners and Drivers Manual. All information and specifications in this manual are based upon the latest product information available at the time of printing.

Table of Content For Hino 2009 Truck Manual:

General Introduction
Clutch Equipment
Clutch Main Unit
Clutch Control
Transmission Equipment
Transmission Main Unit
Transfer Main Unit
Automatic Transmission
P.t.o. (Power Take-off)
Transmission / Transfer Control
Propeller Shaft
Differential Equipment
Differential Carrier
Index: Chassis Group 1/4
Propeller Shaft Equipment
Brake Equipment
Service Brake
Abs & Asr
Es Start (Easy & Smooth Start) System
Exhaust Brake
Retarder Brake
Parking Brake
Steering Equipment
Steering Unit
Power Steering
Axle Equipment
Front Axle
Rear Axle
Wheel & Tire
Suspension Equipment
Suspension
Chassis Equipment
Chassis Frame
Coupler (5th Wheel)
Pintle Hook

Hino Truck 2009 Manual Instruction Extract:

HYDRO MAX BRAKE CONTROLLER INSPECTION

(1) Wire the HYDRO MAX brake controller, buzzer, motor relay and others as shown in figure.
(2) Check operation
a. When IG on, an alarm is carried out by motor monitor low voltage. If the motor monitor is low voltage after high voltage, warning stops.
b. An alarm is carried out by high voltage of motor monitor and IG on.
c. An alarm is carried out by opening of motor monitor circuit and IG on.
d. Electric power is supplied to the motor relay coil with IG on or brake switch on.
NOTICE
“IG on” means starter switch is turned on.