John Deere Two-Piece Front-Wheel Drive Axles 730 to 755 (Version 2), 6R, 6M, and 6RCMC Component Technical Manual (CTM412719)

Table of Content (CTM412719 – Component Technical Manual)

• Section 00 — Safety and General Repair Information
  • Group 01 — Safety Information
  • Group 02 — General Repair Information
• Section 10 — Front-Wheel Drive Axles
  • Group 000 — Axles in Section 10
  • Group 005 — Trunnion
  • Group 010 — Planetary Drive and Wheel Hub
  • Group 015 — Steering Knuckle and Wheel Angle Sensor
  • Group 020 — U-Joint Drive Shafts
  • Group 025 — Steering Cylinder and Tie Rods
  • Group 030 — Axle Housing and Bevel Pinion Drive Shaft
  • Group 040 — Differential
  • Group 100 — Description and Theory of Operation

The same axle numbers are used for the version 1 axles, but these are not mentioned in this manual. Version 1 (left) is used for 6×20 and 6×30 tractors. Version 2 (right) is used for 6R,6M, 6RC, and 6MC tractors. Identify the axle version by looking at the center part of the axle. Version 1 has a square center part and version 2 has a trapezoidal center part.