John Deere Front Axles (AS, APL Series, Dana, Carraro and John Deere) Component Technical Manual (CTM8193)

Table of Content (Component Technical Manual – CTM8193 )

Section 00—Safety
Group 00—General Safety Information
Section 01—AS 2060, AS 3050, and AS 3060 Axles
Group 05—Special Tools
Group 10—General Repair Information
Group 15—Steering Rod and Cylinder Rod
Group 20—Final Drive and Wheel Hub
Group 25—Joint Housing and Drive Shafts
Group 30—Axle Housing and Differential
Section 02—AS3035 Axle
Group 05—Special Tools
Group 10—Axle Views
Group 15—Planetary Transmission and Wheel Hub
Group 20—Differential
Group 25—Steering Cylinder and Steering Rod
Group 30—Center Bearings
Section 03—APL Axles
Group 05—Special Tools
Group 10—Axle Views
Group 15—Planetary Transmission and Wheel Hub
Group 20—Differential
Group 25—Steering Cylinder and Steering Rod
Group 30—Center Bearings
Section 04—720 Dana Axles
Group 05—Special Tools
Group 10—Steering Rod and Cylinder
Group 15—Wheel Hub, Steering Knuckle and Final Drives
Group 20—Axle Housing and Differential
Section 05—725 Dana Axles
Group 05—Special Tools
Group 10—Steering Cylinder and Steering Rods
Group 15—Planetary Drive and Wheel Hub
Group 20—Knuckle Housing and Drive Shafts
Group 25—Axle Housing and Differential
Section 06—750 and 755 Dana Axles
Group 05—Special Tools
Group 10—General Information
Group 15—Tie Rods and Steering Cylinder
Group 20—Planetary Drive and Wheel Hub
Group 25—Joint Housing and Drive Shafts
Group 30—Axle Compartment and Differential
Section 07—John Deere Axle
Group 05—Special Tools
Group 10—Planetary Drives
Group 15—Linkage
Group 20—Pinion and Differential
Group 25—Steering Cylinder
Section 08—Carraro 2WD Axle
Group 05—Special Tools
Group 10—Axle View
Group 15—Steering Assembly
Group 20—Wheel Hub
Group 25—Axle End
Group 30—Axle Joint Bushing
Group 35—Axle Toe-In
Group 40—Turning Angle
Section 09—Dana 2WD Axle
Group 05—Special Tools
Group 05—Dana 2WD
Section 10—20.09 Carraro Axle
Group 05—Special Tools
Group 10—Steering Rod
Group 15—Final Drive, Wheel Hub and Joint Housing
Group 20—Axle Housing and Drive Shaft
Group 25—Differential
Section 99—Dealer-Fabricated Tools
Group 05—Dealer-Fabricated Tools
Section 200—Description and Theory of Operation
Group 25—Description and Theory of Operation