Kobelco SK13SR Excavator Service Manual

TABLE OF CONTENT: Service manual

SPECIFICATIONS
MAINTENANCE
SYSTEM
DISASSEMBLING
TROUBLESHOOTING
ENGINE
INSTALLATION PROCEDURES
FOR OPTIONAL ATTACHMENTS

Preface Instructions

Read and understand all Warning plates and decal on the machine before Operating, Maintaining or Repairing this machine. The manual has been written for the repair specialist. The serviceman or mechanic may be unfamiliar with many of the systems on this machine. This makes it important to use this manual and be caution when performing service work.

Please go carefully through the Shop Manual of the Excavator before starting any repair work. Use proper lifting procedures when removing any components. Be careful when removing filler caps, breathers and plugs on the machine. Hold a rag over the cap or plug to prevent being sprayed or splashed by liquids under pressure. The danger is even greater if the machine has just been stopped because fluids can be hot.

Use the Shop/Service Manual of the SK13SR Excavator as a reference book and source of information even if you are familiar with Excavator technology. Using the Workshop Manual, the experience construction machine mechanic can carry out any necessary repairs expertly.

Sections of the Manual

How to Index each Service manual section. The General of his Service Manual consists of 8 heading as shown above. Each section can easily referred to by indexes appended to the margin of the page as indicated on the right.

REPAIR and Parts

Carry out any necessary repair work as soon as possible.This reduces repair costs and increases the availability of your Excavator. When doing any work on the Excavator, always observe the instructions given in the Manual. Do not operate this machine unless you have read and understand the instructions in the SERVICE MANUAL. Improper machine operation is dangerous and could result in injury or death.

DRAIN RATE OF TRAVEL MOTOR

(1) Preparation
1) Stop the engine, and release air inside the hydraulic oil tank.
2) Disconnect the slew motor drain hose at the return side to the hydraulic oil tank. Then receive the drain oil to a container.
Install plug on bore of tank after removing drain hose.
(2) Measurement:
– Engine At rated speed Hydraulic oil temp. ” 50 ~ 60 C (122 ~ 140 F)
-Machine posture- Pushing fixture with the side of bucket, operating the engine.
-Measurement e drained volume f oil for 30 seconds relieving at full stroke of the slewing operation