Komatsu D63E-12 Dozer Service Manual

Table of Contents

00 Index and foreword
01 Specification
10 Structure, function and maintenance standard
20 Standard value table
30 Testing and adjusting
40 Troubleshooting
50 Disassembly and assembly
90 Diagrams and drawings

1. General Instructions
This section presents under one heading the basic information and procedures common to the sections on “Disassembly and Assembly”, “Testing and Adjustments”, “Troubleshooting”, and “Removal and Installation”. It is essential for the serviceman to thoroughly understand and know this section till it becomes a part of his common sense.

2. Structure and Function.
This section gives a detailed explanation of the “Structure” with details and drawings of the “Constituent Parts” and “block” or “circuit” diagrams, arranged for the serviceman, but also useful as a textbook for training service personnel. The Training Aids should is use to cover the basic theory in this Manual.

3. Testing and Adjustments.
Procedures of all the necessary “Tests” and “Adjustments” are describe with photographs showing the necessary measuring equipment and the location for making the measurements. This should aid the serviceman in his trouble shooting, checking and adjusting work.

4. Troubleshooting
Typical common troubles are listed and systematically described; with their causes and the procedures for finding and diagnosing the symptoms.
As it is impossible to list all of the possible troubles, the serviceman should study the sections covering the “Structure and Function” and “Testing and Adjustments” and apply this knowledge to diagnose any non-listed troubles.

5. Manual Specifications
In this section, all standard dimensions and tolerances that are necessary to perform Testing and Adjustments is mention with drawings together with, appropriate procedures for disassembly and assembly, performing repairs, or troubleshooting. However, basic dimensions and tolerances, for repairs or rebuilding, are limited to those machine parts most commonly worked on.

Drying wiring harness
If there is any oil or dirt on the wiring harness, wipe it off with a dry cloth. Avoid washing it in water or using steam. If the connector must be washed in water, do not use high-pressure water or steam directly on the wiring harness. If water gets directly on the connector, do as follows.
1. Disconnect the connector and wipe off the water with a dry cloth

– If the connector is blown dry with compressed air, there is the risk that oil in the air may cause defective contact, so remove all oil and water from the compressed air before blowing with
air