Kubota B1710, B1710D, B2110, B2110D, B2110DB, B2110HDB Tractor Workshop Service Manual

Kubota Tractor Model B1710, B1710D, B2110, B2110D, B2110DB, B2110HDB
Format: PDF
Publication: 9Y011-12751
Language: English
Kubota B1710, B1710D, B2110, B2110D, B2110DB, B2110HDB Tractor Workshop Manual – 370 Pages

Table of Content of the Workshop Service Manual

This Workshop Manual has been prepared to provide servicing personnel with information on the mechanism, service and maintenance of KUBOTA Tractor B1710, B2110, B2410 and B2710. It is divided into two parts, “Mechanism” and “Servicing” for each section.
■ Mechanism
Information on the construction and function are included. This part should be understood before proceeding with troubleshooting, disassembling and servicing.
■ Servicing
Under the heading “General” section comes general precautions, check and maintenance and special tools. Other section, there are troubleshooting, servicing specification lists, checking and adjusting, disassembling and assembling, and servicing which cover procedures, precautions, factory specifications and allowable limits.

Disassembling Brake Pedal and Parking Brake Lever

(Brake Pedal)
1. Remove the right hand side step.
2. Remove the HST pedal. (HST Model)
3. Remove the spring lock pins (12) and disconnect the brake rods (10), (13).
4. Remove the return springs (9), (11).
5. Remove the external snap ring (7) at the end of the brake pedal shaft (1).
6. Remove the clevis pin (4) of the brake pedal LH (5) and remove the clevis pin (3) of the clutch pedal (2).
7. Pull the right and left brake pedals from the brake pedal shaft (1).
8. Tap out the brake pedal shaft (1) to the left, and remove it with the clutch pedal (8).
(Parking Brake)
1. Remove the lock nuts and remove the parking brake rods (15), (19).
2. Remove the spring lock pins (12), (14) and disconnect the brake rods (10), (13).
3. Disconnect the parking brake arm (16) from parking brake lever plate (21).
4. Remove the clevis pin (17) and remove the parking brake arm (16) and arm shaft (18).
5. Remove the parking brake lever (20) and parking brake lever plate (21) as a unit.
(When reassembling)
• Apply grease to the brake pedal shaft.
• Be sure to adjust the brake pedal free travel and parking brake lever travel (See page 5-S3, S4).