Massey Ferguson 6712S, 6713S, 6714S Tractor Manual

Model: Massey Ferguson MF 6700 Series Tractor
Format: PDF
Language: English
Publication No: ACT0025630

Massey Ferguson 6712S, 6713S, 6714S Tractors Workshop Manual – 1378 Pages
Technician Service Book – MF 6700 S – 758 Pages
AGCO Power 5th Generation AWF Engines – 198 Pages
Spicer Axle 735 and 740 Service Manual – 176 Pages
Parts Catalog Dyna – 496 Pages & 438 Pages

Manual Table of Content

1 Introduction
2 Separation of assemblies
3 Engine
4. Clutch
5. Gearbox
6. Rear axle
7. Power Take Off
8. Front axle
9. Hydraulics
10. Electricity
11. Electronics
12 Operator environment
13 Accessories
14 Service Tools

Removing/refitting the pump

Procedure
1. Remove and refit the cover plate (see chapter Removing/refitting the cover plate, page 9-149 ).
2. Remove the screws (2) and release and remove the pump (32). Remove the “O” rings (22) (23).
NOTE: The centring pins (21) are force-fitted into the cover.

Refitting
Procedure
1. Clean the components and replace any defective parts. Check that none of the related cover plate channels are obstructed.
2. Fit the centring pins (21) to the cover plate (if required).
3. On the cover plate, fit new “O” rings (22) (23) in the recesses of the high and low flow rate channels.
4. Inside the cover plate, apply a bead C of Loctite 574 or equivalent around the four pump screw holes.
5. Refit the pump on the centring pins.
6. Smear the screws (2) with Loctite 221 or equivalent, and tighten them to a torque of 10 Nm–12 Nm.
7. Reassemble and refit the cover plate (see chapter Removing/refitting the cover plate, page 9-149 ).