Mitsubishi FBC15K, FBC18K, FBC18KL Lift Truck Manual

Lift Truck Forklift Model: FBC15K, FBC18K, FBC18KL
Publication 99759-74120
English
Format: PDF

Mitsubishi FBC15K, FBC18K, FBC18KL Forklift  Service Manual: 230 Pages
Controller Manual: 154 Pages

Forklift Manual Table of Content:

• General Information
• Front Axle & Reduction Differential
• Transfer Assembly
• Rear Axle
• Brake System
• Steering System
• Hydraulic System
• Mast and Forks
• Troubleshooting Section
• Maintenance Service Data

This service manual deals with all components or systems of the Mitsubishi Forklift Trucks, except for the electrical system, which is covered in a Controller manual

Tie Rods and Pins

Kingpins
Check the kingpins for any surface flaws such as grooving or stepped wear. Inspect the pins for cracks at the bearing shoulder.

Kingpin Bearings
Examine the rollers and bearing races for grooving, abrasive wear, pitting, bruising, or corrosion.
Replace both the cup and cone of damaged bearings.

Knuckles
Inspect the inside of each knuckle for wear or damage. Be sure to examine for casting cracks.
Check the tie rod pin hole. Examine the wheel nut threads for damage.

Cylinder Rod
Examine the rod for surface or plating damage.
Inspect the rod for straightness. Examine the piston for damage. Check the tie rod pin hole for damage or wear.
Seals and O-rings
Examine all seals and O-rings for damage such as cuts and tears. Replace seals which show signs of aging.

Hydraulic Pipes
Inspect the hydraulic pipes for cracks, especially at the joints with the end fittings. Check for leaks.

Tires
Check the height of the solid rubber portion and, if worn down to 25.4 mm (1 in.), replace the tire.