Takeuchi TL8 Compact Loader Service Manual

Type: Loader TL8
Format: PDF
Language of the Manual: English

Takeuchi TL8 Service Manual – 352 Pages

For All applicable S/N

The manual describes operation, service, repair and maintenance of the Loader, as well as safety instructions that should be follow.

The Takeuchi TL8 manual is intended for persons who engage in maintenance operations, and explains procedures for disassembly and reassembly of the machine, check and maintenance procedures, maintenance reference values, troubleshooting and outline specifications, etc. Please use this Takeuchi manual for Loader TL8 as a reference in service activities to improve maintenance techniques.
Please note that the contents and diagrams included in this manual may not match your machine exactly.

Items or diagram which manual contains are subject to change without notice due to design modifications, etc. Always store the Takeuchi Loader manual near at hand preferably on the machine itself. When transferring ownership of this machine, be sure to provide the owner manual to the next owner.

Table of Content of TL8 Instructions Manual:

I . GENERAL
II . SPECIFICATIONS
III. MACHINE CONFIGURATION
IV. HYDRAULIC UNITS
V . TROUBLESHOOTING
VI. ENGINE

Before operating, perform the prescribe inspections and make repairs immediately should any irregularities be found. If a failure that causes loss of control such as steering, service brakes or engine occurs, stop the machine motion as quickly as possible, follow the shutdown procedure, and keep machine securely park until the problem is fixed.

Extract from the Service Manual:

Removing the lever stands
1. Tilt up the canopy.
•Tilting up the canopy
2. Remove the floor.
•Removing the floor frame 3. Remove the left lever stand.
a. Remove the cover (1).
b. Disconnect the hydraulic hoses from the pilot valve (2).
• Attach identification tags to the hydraulic hoses to ensure that they are put back in the proper places during reassembly.
c. Disconnect the electrical wiring (3).
4. Remove the right lever stand.
a. Remove the cover (4).
b. Disconnect the electrical wiring (5).
c. Disconnect the hydraulic hoses from the pilot valve (6).
• Attach identification tags to the hydraulic hoses to ensure that they are put back in the proper places during reassembly.
Installing the lever stands
To install, follow the same procedures as for removal but in the reverse order.